Hello, I went to the Galaxy factory a couple of months ago to inspect the 250 Adventure as a China MOto buddy recommended this bike. I ordered one and paid for it there and then. They delivered to my home and I had to do some assemby. Anyway, I like the bike and the look and the motor...but i had many problems because they use very low quality parts...and design flaws...also workmanship poor during factory assembly. i called the factory rep and sent 5 emails of problems....NO RESPONSE after phone contact to my emails. See below: during the first 800 kilometers:1) Engine vibration very bad, unable to drive long distance
2) Fuel Line fell off, spilling gas......rubber tubes old
3) Engine fuel adjustment too rich causing black smoke from exhaust and engine stops frequently
4) Headlight bulb stopped working and headlight adjustment difficult to light the road properly
5) Screws that hold the skid plate were not installed straight and cannot be removed
6) Throttle Cluster does not fit properly on handlebar and moves down when opening the throttle. Unable to open throttle completely
7) Horn works sometimes
8) 12v power supply cap does not stay close
9) Ignition Unit comes out of the body
10) Rear Fender (Mud Guard) fit poorly covering the Brake Light, cannot see light
11) Chain requires adjustment every two hundred kilometers
12) Steering Lock fell off while driving
13) Exhaust (Muffler) inside material coming out at the seam

14) Spark Plug wire came apart
15) Motorcycle Stand lean bike too far over (Kick Stand)