Qingqi QM200GY-BA Super Motard
Is this a Q-Link Model? Great info here...(won't spill to much about me) but I've been in the Chinese Powersport Industry for a few years and it reminds me of the Japanese bikes back in late 60's early 70's trying to figure out "moto-cross" bikes! The Chinese bikes have made great strides, but still have a very long way to go.....Best of luck and keep up the good info.
Qingqi QM200GY-BA spokes and sprocket bolts.
Quote:
Originally Posted by
ChinaV
#1 The spokes and the rear sprocket must be checked every 1000 kilometers. If the spokes get loose, you may end up sheering the bolts off the rear sprocket. I had to purchase an entire rear wheel assembly. Should have checked spoke tension more often. #2 The stator failed during the trip and would not put out enough electricity to charge the battery. I'm going to try and find a Suzuki DR200 OEM Stator to replace the original. Other than that, a great little machine!
Two posts in the same thread by different folks that mention loose spokes and sprocket bolt failure... This is too much of a coincidence.
I have found one or two spokes loose, but was happy to see Qingqi using bent-over tab washers for security of the sprocket bolts. Of course this is no good if the steel is of poor quality.
I will be changing them for some high tensile steel items, grade 10.9 or better. (Hardware comes in grades according to its material and tensile strengh. The grades are: 4.6, 4.8, 5.8, 8.8, 9.8, 10.9, and 12.9. Ordinary stuff like mudguards and the like usually have the 5.8 grade, whilst suspension and transmission items should have 8.8 or better). Good concise guide about bolts here: http://www.qldcorvetteclub.com.au/te...talk/bolts.htm
Thanks for the warning on that.
We need 6x M8x30 mm High-tensile bolts, but can re-use the security tab washers:
http://www.telecable.es/personales/a...i/sprocket.jpg
We all know that turning on lights, etc, puts extra load on the engine, but most bike engines have sufficient torque at idle and don't even notice this. The Qingqi is peculiar in that switching on the headlight at idle makes the engine slow down by some 200-300 revs...this could have something to do with the poor stator, as you say.
Another clue is that the regulator (just in front of the petrol tank on the right) runs very hot, even though it is in a superb place to receive plenty of cooling air. Just put your hand in the fins after a run.
Any heat in a regulator device is a loss and the Qingqi one is running at a poor level of efficiency.
If you do find a DR200 stator, could you give us the part number?. This is to be able to walk into the Suzuki dealer, with head held high and ask for the correct item straight away. If not, the question will be: What bike, year, etc is it for?. When you answer "qingqi" they either fall about laughing, or their expression goes blank.