Stolen from EN125 service manual
http://i59.tinypic.com/34zmt8l.jpg
Printable View
Stolen from EN125 service manual
http://i59.tinypic.com/34zmt8l.jpg
That spring was behind the oil filter, you removed the nut for the oil screen there is no spring there. There is another plug to drain the oil its not center, that center bolt is for the oil screen. Either one will let the oil out.Quote:
Originally Posted by impulsive
the drain plug on page 5 #10
the strainer is on page 11 #13
http://www.atvpart.ru/files/3_1.pdf
nope was not oil screen nut, was the drain nut just off from there for the clutch side of bike i thinkQuote:
Originally Posted by MJH
been spraying the tank
http://s28.postimg.org/eat1vgke5/DSCF0130.jpg
http://s27.postimg.org/es3uu00c3/DSCF0135.jpg
sprayed a few coats of 2k lacquer over the new swinging arm i bought :)
got the 2 heads off the engine almost identical, can I use the one from my pulse that doesn't have a speedo drive on the Suzuki engine?
http://s27.postimg.org/63pnysmr7/DSCF0247.jpg
Why putting a "castrated" on old GS? Pulse: Smaller valves.
---
con rod: new "FLAT" = 2.3MM > old http://www.motorfans.com.cn/bbs/t_16975339.htm
just looked abit cleanerQuote:
Originally Posted by humanbeing
also not using pulse head, just using rocker cover from pulse as the Suzuki rocker has a speedo drive built in but it is quite mangled on the outside and am worried it may leak water in to the engineQuote:
Originally Posted by humanbeing
The risk of this mod is low if the measurement isn't too far away btw 2.Quote:
Originally Posted by impulsive