Re: Squeaking Disc Brakes
Re: Squeaking Disc Brakes
Bleed out some brake fluid, down there, on the brake caliper.
Re: Squeaking Disc Brakes
Humanbeing and Zorge, thanks guys, both of you were really helpful. Great!
Re: Squeaking Disc Brakes
It is possible your pads are contaminated from getting anything from a cleaning agent,WD40 or picked up some oil on to the rotor.Take it out for a run and get some heat into the rotor and pads it might burn it out or it might just need to be bedded in being new.
I'd be wary of bleeding the brakes out down there if you get some brake fluid on the rotor and pads they truly will be contaminated.If you must bleed the brake I would get someone to help you.
Re: Squeaking Disc Brakes
Quote:
Originally Posted by
bigdamo
I'd be wary of bleeding the brakes out down there if you get some brake fluid on the rotor and pads they truly will be contaminated.If you must bleed the brake I would get someone to help you.
In fact, this is one man job. You need 8mm open-end wrench and piece of transparent hose with a diameter approximately equal to the diameter of the nipple for discharging brake fluid.
Pull the hose to the nipple and direct it upwards, loose the screw/nipple, press the brake lever until the hose is filled, say, with about three inches of brake fluid. Then, without releasing the brake lever, tight the screw/nipple. In the end, pinch the lower end of the hose, so brake fluid could not drain out, separate it from the nipple, and that's all. If you still hear the squeaking, you can repeat the process. Minut and a half job.
Something like disclaimer: this refers to the case that all other components of the braking system working the way they should work.
How's my English? Did you understand my "words of wisdom"? :lol8:
Re: Squeaking Disc Brakes
Quote:
Originally Posted by
Chinggis101
I discovered it has a very noisy squeak from the front disc. Suggestions?
Hi Chinggis, I have always used copaslip on squeaky pads. You need to separate the pads, remove them and smear the back [the BACK] with copaslip. Pop them back in. Works every time for me. IMHO it is probably not the fluid circuit from what you describe.
Haven't looked for copaslip in China, but I guess there is some version of it available. I have had the same tube for about 20 years!
Re: Squeaking Disc Brakes
Quote:
Originally Posted by
Zorge
In fact, this is one man job. You need 8mm open-end wrench and piece of transparent hose with a diameter approximately equal to the diameter of the nipple for discharging brake fluid.
Pull the hose to the nipple and direct it upwards, loose the screw/nipple, press the brake lever until the hose is filled, say, with about three inches of brake fluid. Then, without releasing the brake lever, tight the screw/nipple. In the end, pinch the lower end of the hose, so brake fluid could not drain out, separate it from the nipple, and that's all. If you still hear the squeaking, you can repeat the process. Minut and a half job.
Something like disclaimer: this refers to the case that all other components of the braking system working the way they should work.
How's my English? Did you understand my "words of wisdom"? :lol8:
Yeah your English is good(Gee I seem to be saying that alot lately)I understand your "words of wisdom"
Alot easier to have a friend " press the brake lever " squeeze pump the brake lever to get all air out of the system while you just work opening and closing the screw/nipple three feet away making sure the brake fluid goes into your over flow bottle not all over your rotor and pads.
Yeah I can do it myself but I much prefer someone helping me hell I'll even get the finance minister to help me if I can't find someone else.:naughty:
Plenty of experience doing moto bleeds and far to many MTB bleeds.MTB disc brake bleeds would have to be the most temperamental of all disc brake systems to bleed.
Re: Squeaking Disc Brakes
Thanks for all the words of wisdom and advice.
BigDamo, no licence, bike and I, so the road option is not possible. I thought that a good burn might sort it out but no can do. However I do have a couple of steep hills in the complex and a good 3 km ride so I'll keep working at it.
Zorge, your English is fine and so are your instructions, but I think BigDamo's caution is probably advised. I've been around bikes long enough to know that sometimes simple things can go very wrong. I don't have the back up to sort out complications arising from a brake fluid escape, besides it'll stain the rim I would guess.
I was wondering if there was a product I could put on the pads or the disc that might do the trick. Lobotomous, copaslip sounds like a workable solution. I see I should be able to get it in the UK.
Re: Squeaking Disc Brakes
Quote:
Originally Posted by
Chinggis101
Thanks for all the words of wisdom and advice.
BigDamo, no licence, bike and I, so the road option is not possible. I thought that a good burn might sort it out but no can do. However I do have a couple of steep hills in the complex and a good 3 km ride so I'll keep working at it.
Zorge, your English is fine and so are your instructions, but I think BigDamo's caution is probably advised. I've been around bikes long enough to know that sometimes simple things can go very wrong. I don't have the back up to sort out complications arising from a brake fluid escape, besides it'll stain the rim I would guess.
I was wondering if there was a product I could put on the pads or the disc that might do the trick. Lobotomous, copaslip sounds like a workable solution. I see I should be able to get it in the UK.
wait until yo get your license and rego sorted out then you can take the bike for a ride then you will be able to better appraise what needs to be done i'm betting being a Chinese motorcycle alot of things will need to be looked at.
Re: Squeaking Disc Brakes
Take a pencil (the softer, the better) and draw waves on both sides of the rotor. Yeah, I know, but It worked for me. I've read it a few different places and it took the squeak from my Qlink (Quinqi) front brake.
