Another Aussie 650nk

Hey guys

Names Mitch live in Australia.

Bought myself a 650nk few weeks ago at auction however wasn't in the condition it was listed at!

So while I'm waiting for parts I'm looking at mods such as handle bars. Bar end mirrors. Pod filters and am looking for some advise on which to go with.

What size pods are recommended?

What bars have others used and what other models fit?

Ecu tuning, can anyone recommend anything special mine is LAMS restricted (also wanting to remove this too!)

Thanks in advance.

Hello, I used the bars with raisers from Chinese taobao.com

http://item.taobao.com/item.htm?spm=...id=12471975835

this is the link.
These bars won't take bar-end mirrors though, since the internal diameter is too small.
As for the pods, I would highly NOT recommend installing those, since you will need to remap your ECU to have your engine run properly.
Can't say much about ECU tuning, but I guess that the rte should be ways to remove LAMS restriction. Probably a new ECU + reflash would work.

Thanks for the reply, looks like they have a 22mm internal diameter - most of the bar end mirrors i've been looking at are 22mm so that shouldn't be an issue.

What size risers did you use? how do you find these bars compaired with the standard ones?

thanks again

Quote:

---

Originally Posted by bov17

Thanks for the reply, looks like they have a 22mm internal diameter - most of the bar end mirrors i've been looking at are 22mm so that shouldn't be an issue.

What size risers did you use? how do you find these bars compaired with the standard ones?

thanks again

---

I think those bars I posted the link to have 12mm internal diameter, not 22. I use the risers that went with the bars, they are probably 4-5 cm.
Anyways, the bars are wider and I feel much more comfortable with them. The underside is that it makes filtering a bit more complicated.

I have used Rizoma conical handlebar (Fatbar) model MA010 what are low and don't have much bend.
As they are not 22mm but about 29mm in the connection point.
So do you have to use some risers adapters to connect them as our bikes
you just can't go and change risers.

When I replaced my front end I also replaced my triple tree so I can now change my risers.
Here is my setup before my fork upgrade.

Attachment 15756
Attachment 15757

Wald0, that's a bomb! Looks awesome!!!

So I've decided to make the bike single seat and make a real cowl for the back seat. I'll take some pics of my new bars bar end mirros exhaust and rear cowl when I get home :)

And this is my progress so far - new bars and bar end mirrors
new exhaust and filters as well as progress on rear seat cowling

http://i59.tinypic.com/34ytbte.jpg
http://i58.tinypic.com/j81b39.jpg
http://i61.tinypic.com/34y4qhe.jpg
http://i57.tinypic.com/1zwmcr5.jpg

Attachment 15996

Nice mod! I'd like to see it on the bike.

will get a pic on the back of the bike when its finished in a day or two :)

Here you go @ZMC888 - on the bike and finished! Very happy with my first ever attempt at making something out of carbon fibre!

http://i62.tinypic.com/smq61k.jpg

http://i60.tinypic.com/29uxe0w.jpg

http://i60.tinypic.com/33arub7.jpg

How's the mods going? Any update?

don't suppose your likely to manufacture anymore of these pillion covers to supply to less handy forum members:) Seriously that's a really good looking mod