Re: Dong Fang DF 250 RTB Bobber Information
Quote:
Originally Posted by
reporon
as long as we are talking valves, did anyone else have the problem after adjusting valves to specs. they sounded good until warmed up then they rattled like crazy. i would think they would quiet up more when warm. after trying everything i could come up with. I set them both at zero. I even tried zero on intake and 2 on ex. still major rattle.
reporon,
My valves make a little noise on all my bikes when warmed up which is correct on an non hydraulic valve lifter engine.
Don't run your valves set at zero clearance because you will cause engine problems like burned valves. The owner's manual has the clearances.
Are you sure that the loud noise you hear is the valve rocker arms? The catalytic converter in the exhaust pipe on my DF make a rattle.
3 Attachment(s)
Re: Dong Fang DF 250 RTB Bobber Information
here are the pics of the new west eagle seat and mounted GPS, i'll take a ride tomorrow to check the difference of the GPS and my bike's speedometer if the rain holds out.
Attachment 5983Attachment 5984Attachment 5985
Re: Dong Fang DF 250 RTB Bobber Information
my bike also starts n runs quitely untill warm then the valves "tick" , just the nature of pushrods
this made me think , has anyone successfully installed an oil cooler ?
Re: Dong Fang DF 250 RTB Bobber Information
Quote:
Originally Posted by
hooliganboy
here are the pics of the new west eagle seat and mounted GPS, i'll take a ride tomorrow to check the difference of the GPS and my bike's speedometer if the rain holds out.
Attachment 5984
Where did you get that seat? Did it come with the springs also? Looks great. I'm afraid to ask how much was it.
Re: Dong Fang DF 250 RTB Bobber Information
Quote:
Originally Posted by
alleykat
Where did you get that seat? Did it come with the springs also? Looks great. I'm afraid to ask how much was it.
I second that about the seat.. sweet seat. need info..do tell!
Re: Dong Fang DF 250 RTB Bobber Information
Quote:
Originally Posted by
alleykat
Where did you get that seat? Did it come with the springs also? Looks great. I'm afraid to ask how much was it.
i ordered the seat off ebay for $119, it didn't come with the springs. i got the springs from motorcycle superstore http://www.motorcycle-superstore.com...T.ac=SLIsearch , these are the 5 inch springs. i also got the front seat bracket off ebay and had to fabricate the rear seat bracket out of some flatbar i got from home depot. i ordered 2 different brackets for the rear but couldn't make either one work so i had no choice but to build one.
Re: Dong Fang DF 250 RTB Bobber Information
Re: Dong Fang DF 250 RTB Bobber Information
Nicely done Hooligan, especially on the spring bracket. I like the bars too.
/M
Re: Dong Fang DF 250 RTB Bobber Information
i think i was a little too ambitious with the 5 inch springs, just a little too much left to right sway, feels a kind of unstable. i think i'm going to try 3 inch springs and see if that makes it better. also, i don't think i'm getting an accurate reading from my GPS. when i switch to second gear at 10mph the GPS says i'm doing 12mph, i glance down while i'm doing 45 and the GPS says 40, i increase speed up to 50 and the GPS still says 40, then at 60 the GPS says 49 and i'm on a 55mph road leaving the car behind me and quickly catching up to the car in front of me. i think i'm just not going to use the GPS and just keep up with the flow of traffic, and if there's no traffic then i'll just do 5mph over the speed limit.
Re: Dong Fang DF 250 RTB Bobber Information
alleykat...that is a very nice looking box you have there.... LOL... after a couple of hours you will have the finest motorcycle that can be had for the money... Congratulations