Re: SHINERAY HUSQVARNA branded S.W.M
Shuben,
Over the last 18 months I have lost some weight, now I am about 80 KGs. From my ride on the Husqvarna TE 300 ( which was a bit over powered for me ) I think the 300 will work out fine. And as long as it can cruise at 100 kph on the roads I will be happy.
I will go to see the local dealer after the holidays to see if I can work out a deal :-)
Re: SHINERAY HUSQVARNA branded S.W.M
Quote:
Originally Posted by
ShuBen
The LED we bought is not cheap but high quality.
The light output is in my opinion worth the investment.
We had concern that the cooler strips would get too hot and burn the wire harness.
This is not the case. The real heat spot is just at the strip exit from housing.
I opened the strip to loops and put them cross over in each other which keeps the cables away from the hot spot.
Attachment 19341
After a 100km run I checked again immediately on arrival and found the strip touchable hand warm.
Attachment 19342Attachment 19343
Of course I dont know whether cheaper products have same conditions.
One thing I find very annoying and this is the left electrical hand control.
Completely untypical they have placed the horn switch in the center and the turn signal down while on all other bikes i owned it was vice versa.
I never find the horn when needed and must look all time to switch turn signals. After getting on my GS i am confused once again.
I have ordered a YBR250 left control block and will (if necessary) re wire it. In case the quality is satisfying I consider to replace right too to keep same design.
Attachment 19344
I want to upgrade my bikes bulbs to these but am worried about wattage. These are 42W and stock bulbs on my bike are 35W.
Do you think installing 2x42W instead 2x35W will be a problem?
Re: SHINERAY HUSQVARNA branded S.W.M
Quote:
Originally Posted by
modron
I want to upgrade my bikes bulbs to these but am worried about wattage. These are 42W and stock bulbs on my bike are 35W.
Do you think installing 2x42W instead 2x35W will be a problem?
A LED LIGHT with 45 W output is about 22 W current draw.
Re: SHINERAY HUSQVARNA branded S.W.M
Thanks for the speedy reply guys. Ill prolly put them on next weekend.
prince
35W...42W....55W... I think its what they take not the output but I might be wrong.
Re: SHINERAY HUSQVARNA branded S.W.M
Quote:
Originally Posted by
modron
Thanks for the speedy reply guys. Ill prolly put them on next weekend.
prince
35W...42W....55W... I think its what they take not the output but I might be wrong.
That is my point a 100 W LED will only draw 50 W from the engine.
Re: SHINERAY HUSQVARNA branded S.W.M
Quote:
Originally Posted by
prince666
That is my point a 100 W LED will only draw 50 W from the engine.
Really? Sounds a bit confusing to me.
Always thought that 100W is 100W juts the light output differs with technology which is measured in lumens.
Anyway, as long as my alternator can cope with 2x42W LEDs ill be happy. And as long as my wiring wont burn of course ;)
Re: SHINERAY HUSQVARNA branded S.W.M
ShuBen has already kindly pointed out, it works with no problem or burns outs.
Re: SHINERAY HUSQVARNA branded S.W.M
Quote:
Originally Posted by
prince666
ShuBen has already kindly pointed out, it works with no problem or burns outs.
For which Im grateful. Will install over the weekend. Thanks