Adventure Motorcycle Magazine Subscribe Now

Search:

Type: Posts; User: lagerlout07

Search: Search took 0.00 seconds.

  1. Replies
    5
    Views
    4,946

    Re: Lexemoto adrenaline electrics dying

    Wd40 down the ignition barrel and turn the key a few times then repeat again for good measure. Make it part of your maintence ritual.
  2. Replies
    2
    Views
    4,921

    Re: Lexmoto Adrenaline 2015 plate

    Your rattle could be a exhaust hum. I have the same engine but a Sinnis vista, my exhaust had another pipe that ran down the inside of the chrome and it used to hum, drove me mental too till I bought...
  3. Replies
    12
    Views
    36,945

    Re: Keeway RKV 125 (K157FMI) Tuning

    No idea with that engine then sorry :)
  4. Replies
    12
    Views
    36,945

    Re: Keeway RKV 125 (K157FMI) Tuning

    Christ where do I start lol
    Yes you can get a smaller filter for the crankcase hose. Either fit it to metal stub on the crankcase or put it on the pipe. Depends on room between bottom of the carb....
  5. Re: Engine temperature with stainless steel exhaust

    http://www.jba.bc.ca/JBCycle/Resources/jet-chart.jpg

    Will help with what and where needs adjusting
  6. Replies
    4
    Views
    5,002

    Re: Mikuni 30mm

    Hi

    Sorry my reply is abit late i have a k157fmi engine and fitted a mikuni 30mm to it. What i did with the setup was fit my old needle, pilot and main jet rod intonthe 30mm and stuck a 115 jet on...
  7. Replies
    2
    Views
    6,759

    Re: Sinnis blade k157fmi big bore kit

    I've sent you a pm response to your pm but you will need to upjet. Buy a few different sizes and do a plug chop test to confirm that the bike has the correct mixtures. Youtube is handy for videos on...
  8. Replies
    3
    Views
    5,398

    Re: k157fmi head bolts

    So they are M8, that's OK then.

    Thank you very much.
  9. Replies
    3
    Views
    5,398

    k157fmi head bolts

    Having a nightmare here so hoping someone can help. Just been doing some maintenance on the bike and removed the head bolts that go threw the engine. I ordered new long bolts but my head nuts are...
  10. Replies
    7
    Views
    9,290

    Re: K157fmi 150cc Cam Question

    I ordered the cam of eBay from america, at the time of looking I couldn't find a 250 and now their are a few on their but double what I paid for the 230. I'll defo probably try a 250 at some point...
  11. Replies
    7
    Views
    9,290

    Re: K157fmi 150cc Cam Question

    Fitted the Cam, was very easy to fit, difference in the bike is unreal, I've yet to set the carb, I checked the plug and it has gone very rich, no doubt from increased airflow so I'm waiting for a...
  12. Replies
    7
    Views
    9,290

    Re: K157fmi 150cc Cam Question

    Hi SanoShaker

    Already done that mod back when i fitted my big bore kit. Have actually ordered and its arrived yesterday a CAM SHAFT LT230-S from discussions on this forum. got one cheap so if it...
  13. Replies
    68
    Views
    118,263

    Re: pulse adrenaline 150cc big bore kit fitted

    Hi, did same job few months back and had exact same thing.
    Buy four new head bolts, a mechanic said they can stress fracture and he would of replaced them. To tighten them in you use two nuts, much...
  14. Replies
    7
    Views
    9,290

    K157fmi 150cc Cam Question

    Hi,

    Had my bore kit fitted for awhile and happy with it, installed a 30mm carb which was a pain to set up but again was another nice boost. But as everyone who does this knows top end power tails...
  15. Replies
    3
    Views
    9,120

    I had this on a sinnis vista. The speedo cable...

    I had this on a sinnis vista. The speedo cable had snapped. Yet it still appeared to work perfectly fine. It drove me mad. I took the cable off and pulled gentlly on the inner cable low and behold...
  16. Replies
    4
    Views
    11,384

    Re: Sinnis Apache gearing?

    My sinnis vista is the same. 60 seems tops for me. I have though just fitted a 110 jet and gone for a run today. It makes a considerable difference but I may have jumped abit too far. I fitted a k&m...
  17. Replies
    2
    Views
    5,551

    Re: cush drive sinnis vista

    Thanks for responding

    I had hoped to have ordered one without me dismantling twice. Ill strip it in a few days and have a look ;)
  18. Replies
    2
    Views
    5,551

    cush drive sinnis vista

    Hi

    Wondered if anyone had needed to replace there's. Just had my bike serviced and they have flagged it up. But I cant find one for my model specifically which is nothing new. I noticed the...
  19. Replies
    5
    Views
    5,459

    Re: sinnus vista 125

    Hi

    tape idea has worked great dave, will last till new one arrives, thank you so much for the idea. Will at least get me too uni :)

    And yes the bike fell to the left, gear shift required...
  20. Replies
    5
    Views
    5,459

    sinnus vista 125

    Hi folks

    After a little help if anyone can, i love this bike and its started giving me a load of problems this last few weeks. I had a nasty fall of it, a bus had broken down and dumped its...
Results 1 to 20 of 20