Search:

Oil filter location is on the left had side of the engine under the flywheel casing.

To change the oil, first you need to remove the drain bolt on the underside of the engine (make sure you have a...

Not sure if your pulse will be the same but when I changed to a 30mm carb on my kinroad 125 I had to make an adapter plate up between the carb and the inlet manifold as it didn't completely cover the...

Strip and clean the carb out
Lean off the fuel mixture by about 1/8 of a turn
And replace the faulty parts and go from there

Try looking for a 2.75-2.75/15 tire.

From looking at pictures on google you change it via the rear of the light unit from under the pillion seat

These are cheaper http://www.ebay.co.uk/itm/271300602911?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649

No worries :) Ride safe

I found these that draw a lot less power ...

Have you sorted out the idle problem?

I run a xenon max ultima H4 in my kinroad but I had to wire the headlight straight from the battery and set up two relays due to the crappy wiring they use.

You could try one first and see if the...

I'm pretty sure you'd only have problems if you went up to 55/60 due to the power draw + heat involved, with the HID route they produce a fair bit of heat which may cause problems.

I've found two that look similar to yours http://89.234.5.225/partno_EXSTMCMP018.php
http://89.234.5.225/partno_EXSTMCMP008.php

If you haven't already sorted something out you could try this with a 45W H4 bulb http://en.wikipedia.org/wiki/User:KDS4444/HS1_bulb

Hello from a Kinroad xt125gy rider from sunny England.

As far as I know your bike isn't fitted with any sort of restrictor's and upgrade wise start with a performance rear can, free flowing air filter and go up one to two sizes with the main jet.