Results 1 to 10 of 47
|
Threaded View
-
#1 QLink/QingQi rack...cause Carl asked me to07-29-2009, 08:02 PM
I got a rear rack for my Qlink XF200 from Carl and he asked me to post some pictures. I had to figure out how to mount the turn signals as they point kind of funky when re-bolting to the rack. I ended up reversing the direction of the mounting bracket after squareing them up a bit in my vice. This points the signals the wrong way so I took off the lenses and pulled the bulb. I then pulled the plastic housing out of the rubber part and turned them the right way. It's not a perfect fit as there is a gloove and slot that mates the parts together but it holds. I wrapped some electrical tape around the joint to make sure it stays. The lenses have to be swapped as they have small notches in them for water drainage. The bolts supplied are ok for the front mounts but need to be a little longer for the back so I replaced those. The original ones for the grab rails can be re-used without any problems. The rack fits perfect . I know that ChinaV had some problems with the one he got for his new 250;
http://www.mychinamoto.com/forums/sh...ht=rack&page=3
All and all I am very pleased with the fit, finish, and price. Thanks again Carl!
....I want those foot pegs that ChinaV has next....
« Previous Thread | Next Thread » |
Similar Threads
-
QingQi 200 GY (Qlink, STx, et al) Repair Manual
By CrazyCarl in forum MaintenanceReplies: 29Last Post: 03-21-2015, 07:56 PM -
Changing fork oil on Qlink QingQi 200
By david3921 in forum MaintenanceReplies: 33Last Post: 12-15-2013, 02:26 AM -
QingQi (Qlink) QM200GY About the clutch
By ChinaV in forum MaintenanceReplies: 19Last Post: 11-17-2012, 01:30 PM -
Exhaust can for Qingqi QM200GY (aka Qlink, etc)
By forchetto in forum MaintenanceReplies: 135Last Post: 06-22-2011, 01:46 PM -
QLink/QingQi 200 Sprockets and Parts
By C&K POWERSPORTS in forum Deals from DealersReplies: 3Last Post: 08-29-2009, 12:54 PM
комедии 2024 русские
04-29-2024, 07:03 AM in Off Topic Discussions