Results 11 to 11 of 11
|
-
#11 Re: Q-Link XF-200 Broken Piece -- Pictures -- Need Help07-14-2010, 04:49 PM
You will never get the screw back in attached, it will just spin the plunger. You need to reattach it and tighten it, then turning it counter clockwise will tension it. Does that make sense? You unscrewed it you did not over tighten it. That bolt screws into the plunger, when tight it then tensions the plunger by turning it counter clockwise. Only one click.
I do not think you damaged it….do you? If so then get a new one.
« Previous Thread | Next Thread » |
Similar Threads
-
Club link and bad translations
By Oengus in forum Off Topic DiscussionsReplies: 5Last Post: 03-20-2010, 06:28 AM -
Mikilon M96 Engine Mounts Broken
By DJCW in forum MaintenanceReplies: 2Last Post: 01-22-2010, 12:51 PM -
Broken Stud in Gas Tank
By txm123 in forum MaintenanceReplies: 4Last Post: 07-11-2009, 01:18 PM -
Direct link to a post in a thread
By chinabiker in forum Test TrackReplies: 4Last Post: 05-21-2009, 08:39 PM -
Lost in Guangxi -The broken spoke diaries
By Supersignet in forum Ride Reports and MeetingsReplies: 24Last Post: 05-13-2008, 04:46 PM
Tags for this Thread |
комедии 2024 онлайн...
04-23-2024, 02:09 AM in Off Topic Discussions