Thread: mucking around, exhaust gasket
Results 1 to 4 of 4
|
Threaded View
-
#1 mucking around, exhaust gasket11-08-2010, 10:20 AM
Can't ride at the moment, balance problems, so time to muck around. Cleaned most of the winter mud and crap off and of course found a fair bit of rust here and there, including 'chromed' parts like front forks which is a worry, grrr. But the rustiest piece of crap on the Kinlon is, so far, the exhaust pipes and muffler and that is the next job to clean up.
What materials have any had success with when making new gaskets? Is copper sheet too hard?
I know I could probably buy a replacement gasket cheaply enough as I assume it is a pretty standard 1 1/2 inch (38mm) part across models/manufacturers (?) - but I like mucking around.
« Previous Thread | Next Thread » |
Similar Threads
-
exhaust pipe
By my_bloody_shineray in forum MaintenanceReplies: 5Last Post: 12-14-2011, 05:25 PM -
My new exhaust on Pulse adrenaline
By Thomas in forum Welcome to MCM!Replies: 26Last Post: 09-06-2011, 11:57 AM -
exhaust
By my_bloody_shineray in forum MaintenanceReplies: 0Last Post: 06-21-2009, 11:51 AM -
A little advice on a new exhaust...
By Rainer in forum Modifications (Cosmetic and Performance)Replies: 7Last Post: 04-20-2009, 02:32 PM -
Hongdou GY200 Exhaust
By Matt in forum Parts DeskReplies: 2Last Post: 12-09-2008, 08:59 AM
Prime Сasual Dating - Real-life...
Yesterday, 08:19 AM in Off Topic Discussions