QM200GY/QLINK XF200 Center Stand

[humanbeing]

can you post the dimensions for those who want to buil it locally?

DiY version:
http://www.motorfans.com.cn/bbs/view...uthorid=215255

[barnone]

hb,
To the rescue as usual.

[felix]

DiY version:
http://www.motorfans.com.cn/bbs/view...uthorid=215255

Good one HB! For the non chinese readers, you probably guessed it but it says inner diameter of that tube is 10mm.

That's actually a very good thread. If you read on to pages 3 and 4, have a look at the exhaust he builds and the matching spare fuel tank. Amazing shit, i want that guy to build me one too!

[david3921]

I agree with you, Felix. Nice stuff there. The tank and exhaust are the shit! I'm curious about the cap as I can only just see a bit of it. I have some questions and can't understand the posts after I translated it . I see the oiler cooler on the left side on page 4. I've never seen a cooler added with having to install the copper block outs that he did, though. Was there a reason for this? On the last page, it looks like he thought better of his design and re-routed the lines with a new oil filter cap. Is that true?

Why is there wire through the carb jet?

Couple of other observations are that this version of the Qingqi motard gets a rear disk and rubber passenger pegs. I've never seen the fake air directing shrouds that large either.

[calimba]

Right now I would not recommend the center stand but maybe a small tweak will fix it for me.

Sorry to bother! Would you mind re-posting your pictures?

[barnone]

calimba,
Sorry but I deleted the photos when I sold the bike to supertimmy who is a member of this site. He has the center stand. Maybe you can PM him for photos.

[pulserdriver]

Good one HB! For the non chinese readers, you probably guessed it but it says inner diameter of that tube is 10mm.

That's actually a very good thread. If you read on to pages 3 and 4, have a look at the exhaust he builds and the matching spare fuel tank. Amazing shit, i want that guy to build me one too!

I can not open this link

I want to make something like this for my bike..

Thanks in advance!

[barnone]

I can not open this link

I want to make something like this for my bike..

Thanks in advance!

Why don't you PM supertimmy and see if he will sell you the center stand.

[pulserdriver]

Why don't you PM supertimmy and see if he will sell you the center stand.

Because just shiping costs from supertimmy to my coutry will be as a small fortune

DIY forever

[barnone]

Because just shiping costs from supertimmy to my coutry will be as a small fortAune

DIY forever

Sorry, didn't see SRB which I assume is Serbia. Anyway maybe supertimmy will take some photos and post them here with dimensions.