Results 1 to 2 of 2
|
-
#1 atv front end setup ????workshop manual ???
- Join Date
- Aug 2011
- Location
- uk
- Posts
- 6
09-06-2011, 09:57 AMwhat are the basic settings for front end geometry of a quad ?
the front end sqeels like a pig around even the slowest road corners ..with or without a back wheel off the ground. i have measured the underside of the frame and all wheel mounts seem to be square, rear axle alined etc .. just dont know what the (tracking ) tow in or out should be also caster camber would be good
WHY ARE THERE NO WORKSHOP BOOKS AVAILABLE FOR CHINA QUADS ???
it lets a reasonable product down.quadd.jpg
-
#2 Re: atv front end setup ????workshop manual ???
- Join Date
- Aug 2011
- Location
- uk
- Posts
- 6
09-25-2011, 08:08 AMi had some time free so i stripped the front end and checked everything was ok. i set the tracking to parallel and it still looked wrong. i then had a friend sit on the quad and re set the tracking to parallel.. it is now much better around corners with no squeeling. i will watch for uneven tire wear and adjust to suit
« Previous Thread | Next Thread » |
Similar Threads
-
Shanghai to Moganshan this week end (19/21 August 2011)
By nicolast in forum Ride Reports and MeetingsReplies: 41Last Post: 08-31-2011, 11:03 AM -
Galaxy Suspension Setup
By richardktm in forum Dirt n' Dual-SportReplies: 0Last Post: 12-13-2010, 01:24 AM -
looking for manual for my zongshen 110 atv
By jmcdonald151 in forum ATV's/QuadsReplies: 2Last Post: 04-30-2010, 11:13 AM -
The beginning of the end for cheap Chinese goods?
By forchetto in forum Industry News and Moto TalkReplies: 1Last Post: 09-19-2008, 06:06 AM -
Workshop manual SYM Jet 50/100 scooters
By forchetto in forum ScooterReplies: 0Last Post: 07-27-2008, 07:13 PM
комедии 2024 онлайн...
04-23-2024, 02:09 AM in Off Topic Discussions