Thread: Pulse Adrenaline Sprockets.
Results 11 to 11 of 11
|
-
#11 Re: Pulse Adrenaline Sprockets.
- Join Date
- Jan 2012
- Location
- Norwich
- Posts
- 408
04-17-2012, 06:05 PMHere you go, sorry about the bad angle, this was the best I could do without removing the carb. I cut the bottle in half then cut a hole on the lid end then cut about 10 - 15 verticle slits along the bottle at the lid end to allow it to stretch over the filter then I secured it with a load of electrical tape. Alternatively you can just cut a 48mm ish diamater hole and put the bottle on the carb first then put the pod filter on.
DSCF0040.jpg
DSCF0043.jpgSinnis Max II (QM125-2V), K157FMI engine (technically a K162FMJ now), 115 main jet, 40 pilot jet, cone air filter, 150cc big bore kit, 17 tooth front sprocket, 30mm carburettor, alarm with remote start, HID spotlights, performance CDI.
« Previous Thread | Next Thread » |
Similar Threads
-
Pulse Adrenaline 125
By superfamous in forum Modifications (Cosmetic and Performance)Replies: 7Last Post: 10-09-2012, 11:32 PM -
Pulse Adrenaline
By jonesyboy in forum Welcome to MCM!Replies: 1Last Post: 10-15-2011, 05:59 PM -
Pulse Adrenaline
By Rodders in forum Dirt n' Dual-SportReplies: 24Last Post: 02-01-2011, 04:47 PM -
Nearly Done; Pulse Adrenaline
By Sprocket in forum Dirt n' Dual-SportReplies: 14Last Post: 10-19-2010, 11:22 AM -
Sinnis Apache/Pulse Adrenaline/Superbyke RMR125 Supermoto alternative sprockets
By k44rll in forum MaintenanceReplies: 0Last Post: 07-01-2010, 10:42 PM
Prime Сasual Dating - Real-life...
Today, 08:19 AM in Off Topic Discussions