My Review of the CFMOTO 650NK

**Topmanda** · 05-24-2013, 02:54 PM

Thank u for ur quick reply Zorge, I was planning to simply cut the edge. I'm just afraid it might not fit as it's supposed to be for dirt bikes.

**Zorge** · 05-24-2013, 03:49 PM

Well, this is no big science. Handlebar diameters may vary from 7/8, 1, to 1 1/4 inches, or even thicker (but their ends are reduced to forementioned masures), but I don't think that CF Motor would experiment with non/standard sizes.

By my experience, the biggest problem may be, not installing new, but removal of the old grips, especially the plastic insert from the throttle grip. But I think that dipping in hot water and spray lubricant will help.

**998S** · 05-24-2013, 11:08 PM

The old ones: just cut loose.

By far the best way to install new ones (after experimenting with every other alternative like soap, hairspray, water, tape, etc) is compressed air.
Have a nozzle with a small exit, and just blow between the grip and the bar, while you slowly push the grip.
It blows up like a blowfish, and as long as you keep the pressure on it, you can position it exactly, even take off again.
No mess with liquids, and tight immediately.
Works like a charm as long as diameters suit.

**Topmanda** · 05-25-2013, 02:56 AM

Cheers for this grandma recipe man ;)

**BBS** · 08-15-2013, 11:50 AM

Hi, which kind of handlebars did u buy?

**Topmanda** · 08-20-2013, 02:14 AM

Handlebar grips: Scott for dirt bike, very thick, but not fully satisfied honestly:
handlebar grips.jpg

Still looking for esthetic/efficient one, guys any advice???

**Wald0** · 08-22-2013, 04:42 PM

Originally Posted by Topmanda

Could someone advise me a shop in Shanghai whith a good amount of accessories for motorbikes? I'm looking for levers (clutch and brake) and a new horn for my 650NK. I heard there's a good one in Gubei area but not sure about the exact location though...

Here's the kind of clutch I'm looking for:
http://item.taobao.com/item.htm?spm=...id=18685251842

If you can advise me a reliable horn system: I'm all hears.

Did you install new horn? and only one? or both? i notice that there are two horns usually in box, HI and LOW?

**Topmanda** · 08-23-2013, 12:34 AM

I installed one only, the High one, keep the other one in case.
Here's mine and it's reliable:
http://item.taobao.com/item.htm?spm=...id=12610507306

**Wald0** · 08-23-2013, 12:39 AM

Originally Posted by Topmanda

I insalled one only, the High one, keep the other one in case.
Here's mine and it's reliable:
http://item.taobao.com/item.htm?spm=...id=12610507306

yes, havent seen that model here (its black so i might have over look it )
but have seen these here
http://en.seger.com/product/50f/
http://en.seger.com/product/45c/

will go market today look those horns. louder the better