Sinnis Aoache 125 idle help

[Bradleyrayner]

Hi there i am stuck and need help with my 125. When i start the bike it revs really high between 3-5000 rpm. When i try and put the choke down the bike slowly cuts out. Looked at the carb and i couldn't actually see the idle screw. Its probably there but i don't wanna start playing with screws that could be important. If someone could help me that want be great and would be much appreciated. By the way my apache is a 58 plate if that makes any difference.

[euphonius]

Dear Bradley,

You get any help with this? I seem to remember someone asking a very similar question a week or two ago, and getting some decent advice. Might have been the RMR Superbyke, which I think is a clone of your Sinnis, or vice versa. Like try this thread for starters.

cheers

[Krasi]

Just a few threads below yours:

http://www.mychinamoto.com/forums/sh...085-Air-Intake

http://www.mychinamoto.com/forums/sh...-when-starting

[spencer2004]

Make sure you have some free play in the throttle, if you dont then adjust it using the adjuster which should be located near the throttle possible covered by a rubber sheath. If that dosen't sort the problem then you can adjust the idle speed using the screw on the side of your carb (not the bottom).

[Bradleyrayner]

Thanks to everyone who has helped. Much appreciated.

[Lowi]

Thanks to everyone who has helped. Much appreciated.

Did you sort it ... what was the problem ??

[Bradleyrayner]

HI there mate sorry its been a while but it still hasnt been fixed. Any other ideas?