Ok so I have my finally taken delivery of my Pulse adrenaline now.

Took it out for a couple of spins and everything was fine, bit of bother getting it started but just put that down to the bike not being used, so battery possibly dying.

When I turn the ignition on all the lights and indicators work but when you hit the ignition switch the battery just clicks away as if its just not got enough power to turn over.

Got a hold of a charger and started charging it, long story short 2 days charging and it still wont turn over now. So while the seat was off I took the opportunity to have a look at the wiring. I now wish I had remained blissfully unaware of it!!! Its a mess, I think there is more insulation tape than wires!

The wires that are there are all badly corroded and in some cases even melted! Some of them dont even connect to anything?!

So ive bit the bullet and ordered the owners manual and a new wiring loom.

My question (eventually!) is does the owners manual come with a wiring diagram or am I just going to have to go into this and work it out for myself? Has anybody had any experience of having to do this kind of thing?