Adventure Motorcycle Magazine Subscribe Now

Page 1 of 10 123 ... LastLast
Results 1 to 10 of 91
  1. #1 New CFMoto 650NK blog x2 
    Senior C-Moto Guru ZMC888's Avatar
    Join Date
    Oct 2008
    Location
    Zibo, Shandong - Sometimes SW England
    Posts
    2,239
    Soberpete and I pulled the trigger on some new CFMoto 650NKs last week, and I got my plates this week so I'm fully legal. Pete's getting the bike in his name so will take a while longer for his plates.

    Anyhow here's me at the plating ceremony...34,500 RMB down.

    WP_20130911_005.jpg

    First thing I noticed...the bars are freaking narrow, I measured them at about 680mm, holy cow I like 720-750mm. Also there's an upsweep of about 70mm, where about 20mm would suit me. Might get some Renthals and some new grips, not sure if I'll get the bar mounts and go with the Fatbar.

    Done about 40kms so far, will be using Loctite 243 and zip tying everything I can find, what did everyone else do on their break-in?
    Reply With Quote  
     

  2. #2 Re: New CFMoto 650NK blog x2 
    Senior C-Moto Guru euphonius's Avatar
    Join Date
    Dec 2009
    Location
    mostly Shanghai, sometimes northern California
    Posts
    3,222
    Wooooohooooooo! So you gonna push the Raptor off a cliff now?
    jkp
    Shanghai
    2010 JH600 "Merkin Muffley" (in Shanghai)
    2000 KLR650 "Feezer Ablanalp" (in California)
    Reply With Quote  
     

  3. #3 Re: New CFMoto 650NK blog x2 
    Senior C-Moto Guru ZMC888's Avatar
    Join Date
    Oct 2008
    Location
    Zibo, Shandong - Sometimes SW England
    Posts
    2,239
    Quote Originally Posted by euphonius
    So you gonna push the Raptor off a cliff now?
    No way! I spent four years getting that bike up to the level of a neglected 1982 Honda CB250N. In fact it's worked very reliably for about the last two years other than cheap component failure.
    Reply With Quote  
     

  4. #4 Re: New CFMoto 650NK blog x2 
    KING of MCM LOL prince666's Avatar
    Join Date
    Apr 2012
    Location
    china (Longkou), Hainan
    Posts
    2,002
    Well done

    Good news about time you moved up a size 34.500 for the bike what about the cost to plate bike . break in drive slow 0-800km 4000 max revs 800-1500 km 6000 max change oil at 500 km and again at 1500km sounds good check the water pump to see if you have a leak and how is 2nd to 3rd gears going up ???

    just got the TR Trade for 39.800 in red will do a report soon is your side stand the same as the TR to short ???
    "Arguing on the Internet is like running in the Special Olympics, even if you win you're still retarded"
    Reply With Quote  
     

  5. #5 Re: New CFMoto 650NK blog x2 
    Life Is Good! ChinaV's Avatar
    Join Date
    May 2008
    Location
    Guangdong, China
    Posts
    1,509
    Congrats ZMC, enjoy every minute of it.

    Cheers!
    ChinaV
    Reply With Quote  
     

  6. #6  
    C-Moto Not-so-Noob guangtouge's Avatar
    Join Date
    Sep 2013
    Location
    Shanghai
    Posts
    15
    Congrats! Enjoy the bike. For break in I tried to keep the revs lower than normal, basically following the manual, though I found myself going over quite a bit. Bike has been fun, and for the most part running great.
    Reply With Quote  
     

  7. #7  
    C-Moto Not-so-Noob guangtouge's Avatar
    Join Date
    Sep 2013
    Location
    Shanghai
    Posts
    15
    Forgot to mention, tighten the tubing going into the radiator. I have heard it has a tendency to work itself loose, and I have had one instance where that had been the case on mine. I have since tightened everything down and not seen another issue.
    Reply With Quote  
     

  8. #8 Re: New CFMoto 650NK blog x2 
    Senior C-Moto Guru ZMC888's Avatar
    Join Date
    Oct 2008
    Location
    Zibo, Shandong - Sometimes SW England
    Posts
    2,239
    Quote Originally Posted by prince666 View Post
    Well done

    Good news about time you moved up a size 34.500 for the bike what about the cost to plate bike . break in drive slow 0-800km 4000 max revs 800-1500 km 6000 max change oil at 500 km and again at 1500km sounds good check the water pump to see if you have a leak and how is 2nd to 3rd gears going up ???

    just got the TR Trade for 39.800 in red will do a report soon is your side stand the same as the TR to short ???
    480RMB or so for plate including insurance. The short kick stand would ideally be maybe 2-4cm longer, but not really terrible, maybe TR sits higher? Was going to do break-in something similar to what you said, but thanks for that.

    Quote Originally Posted by guangtouge
    basically following the manual,
    Anyone got a link to a .pdf English or Chinese, NK or ER6?

    Quote Originally Posted by guangtouge
    Forgot to mention, tighten the tubing going into the radiator. I have heard it has a tendency to work itself loose, and I have had one instance where that had been the case on mine. I have since tightened everything down and not seen another issue.
    Already have some hose clips!

    Quote Originally Posted by V
    Congrats ZMC, enjoy every minute of it.
    I was getting so bored of small displacement bikes I nearly gave up on riding. This should reignite some passion.
    Reply With Quote  
     

  9. #9 Re: New CFMoto 650NK blog x2 
    C-Moto Regular
    Join Date
    Aug 2012
    Location
    United States
    Posts
    55
    Congrats, post some pics of the bike when you time.
    Reply With Quote  
     

  10. #10 Re: New CFMoto 650NK blog x2 
    KING of MCM LOL prince666's Avatar
    Join Date
    Apr 2012
    Location
    china (Longkou), Hainan
    Posts
    2,002
    Anyone got a link to a .pdf English or Chinese, NK or ER6?
    Have a PDF in English owners manual for the NK if that helps so pm your email address and i will send but i need the same for the TR who can help ??
    "Arguing on the Internet is like running in the Special Olympics, even if you win you're still retarded"
    Reply With Quote  
     

Page 1 of 10 123 ... LastLast

Similar Threads

  1. CFMOTO 650NK engine bolts
    By pommie in forum Maintenance
    Replies: 17
    Last Post: 10-01-2014, 02:57 PM
  2. My blog of a WK650i / CFmoto 650NK
    By WirralGhostHunter in forum Street
    Replies: 69
    Last Post: 05-11-2014, 02:40 PM
  3. My Review of the CFMOTO 650NK
    By Topmanda in forum Street
    Replies: 89
    Last Post: 09-24-2013, 12:59 PM
  4. Used CFMoto 650NK for sale in Shanghai
    By bikerdoc in forum Bike Market - Classifieds
    Replies: 1
    Last Post: 08-19-2013, 04:05 PM
  5. CFMoto 650NK sport bike
    By Lao Jia Hou in forum Street
    Replies: 103
    Last Post: 08-28-2012, 04:23 AM
Bookmarks
Bookmarks
Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •