Qingqi QM200GY (Qlink XF200) Raising handlebar height

[david3921]

Well, I bought the set of risers that forchetto recommended and am very pleased. Shipping was super fast, 3 days in the states, and easy installation. Very high quality and packaging. I didn't need to remove the bar pad though. I found that when I lossened the original bolts at the gas tank, the gauge side ones where just snug. When I installed the riser and new bolts I snugged up the gauge side first with the bars rotated enough to access the bolts. Then I rotated the bars to the desired position and tightened the gas tank side bolts.

I also had installed Napoleon style bar end mirrors. They are very similar to the ones forchetto has but with a nut that expands a rubber bushing to tighten them to the bar. This reduces vibration a HUGE amount. The right mirror has no vibration with the left one only a little. I'm going to work to see if I can illiminate it there also. Here's the ones I bought;

http://cgi.ebay.com/ebaymotors/NEW-H...4506.m20.l1116

A little bit more expensive but well worth it for the peace of mind.

[barnone]

There are plenty of 7/8" handle bar risers on Ebay. Do a search. I have these at
http://www.formtechservices.com/dirt...om/RISERS.html
but I don't know if they are the best. They are just risers.

[JTC]

i have a brand NEW set I just ordered on ebay still in the package - Paid $35 will sell for $25 shipped they are 7/8" risers. Here is the link to what they look like:

http://cgi.ebay.com/ebaymotors/ws/eB...=STRK:MEWNX:IT

E-Mail me directly at sales@jamestowncomputer.com I do PayPal or CC over the Phone. PM me ASAP If intrested. 1st come first serve. My Loss is your Gain.

Andrew