Results 1 to 1 of 1
|
-
#1 163 fml - Flywheel cover without starter motor cutout? Big Bore?
- Join Date
- Jun 2014
- Location
- Penzance, England
- Posts
- 1
07-15-2014, 12:08 PMHey all, just gave a 163 fml a full engine rebuild after the kickstart pinion gear seized and destroyed the counter-shaft bearing too. Its going into an XL 125 RC that I have also been restoring (1982). The engine is in and its running great but I really want to lose the starter motor as I'm not putting a battery in it, I'm just using capacitors to smooth out the voltage for the horn and breaklight. I had on hand the XL 125 flywheel cover and it almost matches up but it has one more bolt hole as well as the clutch key being slightly different... Anyone know one that will fit so I can lose the starter motor?
Also I have been looking up big bore kits, I have seen "250" kits that only higher the bore by 2mm which is only something like 215cc. I completely forgot to measure the barrel OD when it was apart to see what I could bore it out to. I also forgot to measure the crankcase mouth to see if I could put a thicker liner in it too... I have seen CG 250 kits and wondered if they fitted? I think that they are 70mm which would take it up to 242cc. Anyone have any experience?
Here is the bike as of now.
Many thanks, Ed.
« Previous Thread | Next Thread » |
Similar Threads
-
New Bike cover for 650TR
By prince666 in forum StreetReplies: 11Last Post: 06-03-2015, 12:48 AM -
QINGQI QM200GY Flywheel and starter clutch
By Lundaahl in forum Parts DeskReplies: 5Last Post: 05-20-2014, 05:42 PM -
125 flywheel removal
By 50dude in forum MaintenanceReplies: 1Last Post: 05-06-2011, 01:10 PM -
ChinaV is finally a cover model!!!
By CrazyCarl in forum Ride, Record, CreateReplies: 6Last Post: 11-16-2009, 09:41 PM -
Cheap Bike Cover
By homebrewed in forum Parts DeskReplies: 0Last Post: 08-19-2009, 02:15 AM
комедии 2024 онлайн...
Today, 02:09 AM in Off Topic Discussions