Screw You!!! HELP!

[Paul.D86]

ok so after some damage was taken to my Sinnis Apache 2015, I need to replace a single screw;

The screw lives on the handlebars, right hand side where the plastic square shaped mount is situated for the electric start button & killl switch, the screw hole faces downwards to the ground on the underside of this component and Is about 1cm wide if not a little larger and its a fairly deep hole at 5cm or so, this screw is missing from here and i am unsure as to what screw size goes in the hole!

Now I've just had a look online at CMPO.com and I believe this is the exact screw I need! anyone know for sure?

thanks

[humanbeing]

Fig C4 of http://startright.co.uk/manuals/sinnis/apacheframe.pdf

[Paul.D86]

ahh thanks humanbeing!!

[Paul.D86]

So I went out and bought a 5mmx20mm flat screw today and waddya know guys it doesnt fit! not even close!

When I put a screw driver into hole its like 50mm deep and definitely wider than 5mm!!!

back to the drawing board

[ShuBen]

can we get some photos of the situation?
Start from distance overview and get closer with two , three detail shots fron various angles.

[Krasi]

So I went out and bought a 5mmx20mm flat screw today and waddya know guys it doesnt fit! not even close!

When I put a screw driver into hole its like 50mm deep and definitely wider than 5mm!!!

back to the drawing board

There must be a second screw there. It might not be the same length, but widths should be equal, i.e. M6 most probably.

[Paul.D86]

Just an update here guys that this issue had been fixed!
Dropped it into a garage as I'd exhausted all ideas I had, mechanic said its usually a small chubby plastic "Cap" that goes in the hole under electric start mount, he had to drill through handlebar with small drillbit and then secure mount on with a small screw, probably just means I may have further issues down the line when I change over to renthal handlebar in new year!

Thanks for help everyone