Results 1 to 4 of 4
|
-
#1 Need help changing rectifier, simple if you know what the wires are
- Join Date
- Jan 2014
- Location
- GB
- Posts
- 5
01-11-2014, 04:16 PMI have a pulse adreniline 125.
The old rectifier i have has 2 plugs.
1 plug has a red and black and white cable attached and the other plug has 3 black cables attached.
http://ecx.images-amazon.com/images/...mL._SY300_.jpg
The new rectifier i have has 1 plug which has
1 red, 1 white, 1 black, 1 green and 1 yellow wire going to the one plug..
http://thumbs2.ebaystatic.com/d/l225...l3kjOaW26g.jpg
The mechanic/parts sales man said to take the wires out the new plug and attach them to the old plugs i have but make sure i get the cables right.
DO YOU KNOW WHAT CABLES ARE WHAT? AS LONG AS I CAN ISOLATE THE 2 CABLES IN THE ONE PLUG , THE OTHER 3 SHOULD BE FINE.
-
#2 Re: Need help changing rectifier, simple if you know what the wires are
- Join Date
- Sep 2013
- Location
- beijing
- Posts
- 35
01-12-2014, 02:03 AMthe reason some manufacturer split the 5 wires is to isolate the output side -
the important thing is that the red and the black MUST go to the battery - the other three can be mixed up -it's not critical.
HTH
marc
-
#3 Re: Need help changing rectifier, simple if you know what the wires are
- Join Date
- Jan 2014
- Location
- GB
- Posts
- 5
-
#4 Re: Need help changing rectifier, simple if you know what the wires are
- Join Date
- Sep 2013
- Location
- beijing
- Posts
- 35
01-12-2014, 02:48 AMthe bike is cutting out - when ? at idle ?
when you are under way the alternator should be making enough power to supply the bike's ignition AND charge the battery.
if it's cutting out when you are underway it's likely a short somewhere - if it's when the RPMs are down low - you likely have a charging issue (which still doesn't mean you dont have a wiring problem)
before spending more money on it - check all your cables and terminations - make sure they are tight, clean and properly connected.
in particular the ground strap - from the negative side of the battery to the frame - assure that the mounting is clean and tight.
if that doesnt fix it - have your battery checked and charging system - do you have a Voltmeter ? if not get one - they can be purchased CHEAP, if so - with the bike turned off , and battery disconnectd- check the voltage at the battery across the terminals. let me know what you get there.
same test- with the bike running battery reconnected at idle- what is the voltage.
same test- with the bike running - increase the engine speed and note if and what is the voltage change as you increase RPMs.
if it's making on top of 13+ volts , when it's running and you note an increase in the voltage as you rev it - your charging system is doing it's job. if not your charging system is suspect.
« Previous Thread | Next Thread » |
Similar Threads
-
110cc extra wires. gear indicator???
By arlie1180 in forum Parts DeskReplies: 6Last Post: 08-03-2015, 06:41 AM -
Simple street bike for the beginning
By Worr in forum StreetReplies: 7Last Post: 06-06-2014, 04:14 AM -
Smoking wires when starting Kinlon 200SM
By halfcasted in forum MaintenanceReplies: 3Last Post: 01-28-2012, 09:02 PM -
Changing Jets?
By firefightermatt in forum Modifications (Cosmetic and Performance)Replies: 22Last Post: 03-18-2011, 11:03 AM