The LED we bought is not cheap but high quality.
The light output is in my opinion worth the investment.
We had concern that the cooler strips would get too hot and burn the wire harness.
This is not the case. The real heat spot is just at the strip exit from housing.
I opened the strip to loops and put them cross over in each other which keeps the cables away from the hot spot.

mmexport1496802481529.jpg

After a 100km run I checked again immediately on arrival and found the strip touchable hand warm.

mmexport1496802466186.jpgmmexport1496802460921.jpg

Of course I dont know whether cheaper products have same conditions.

One thing I find very annoying and this is the left electrical hand control.
Completely untypical they have placed the horn switch in the center and the turn signal down while on all other bikes i owned it was vice versa.
I never find the horn when needed and must look all time to switch turn signals. After getting on my GS i am confused once again.

I have ordered a YBR250 left control block and will (if necessary) re wire it. In case the quality is satisfying I consider to replace right too to keep same design.
mmexport1496802498766.jpg