Results 1 to 5 of 5
|
-
#1 Pulse Adrenaline problem when cold
- Join Date
- Oct 2010
- Posts
- 2
10-06-2010, 08:57 PMHi I hope someone on here would be kind enough to help me.
I have been to look at a pulse adrenaline 125cc which I am looking at buying this weekend. There was just 1 thing which I am not sure if it is an issue or not.
When starting the bike from cold it started fine however you had to leave it for 4 or 5 minutes to warm up before it would let you rev it. If I tried to rev it at all when cold it would just cut out straight away before even slightly revving.
Is this normal? Does everyone else have to sit on their bike for 5 minutes every morning before it works?
Any help or suggestions will be much appreciated.
Thanks
Greg
-
#2 Re: Pulse Adrenaline problem when cold
-
#3 Re: Pulse Adrenaline problem when cold
-
#4 Re: Pulse Adrenaline problem when cold
- Join Date
- Jun 2010
- Posts
- 26
10-07-2010, 03:53 PMits not a problem, lots of 4/ bikes have this "annoyance" simply allow the bike to warm up first as you should with any bike, let it start and dont rev it atall until the idle speed picks up a little, leave it for 5mins have a bru or something then itll be fine
-
#5 Re: Pulse Adrenaline problem when cold10-07-2010, 09:21 PM
Yes, same with Kinloon rt200, in winter anyway it needs a minute or two to pickup, it starts better in summer! Not the bike for a quick getaway when the girlfriend's husband comes back unexpectedly ...
« Previous Thread | Next Thread » |
Similar Threads
-
My new exhaust on Pulse adrenaline
By Thomas in forum Welcome to MCM!Replies: 26Last Post: 09-06-2011, 11:57 AM -
Nearly Done; Pulse Adrenaline
By Sprocket in forum Dirt n' Dual-SportReplies: 14Last Post: 10-19-2010, 11:22 AM -
New exhaust for pulse adrenaline 125
By *greg* in forum Modifications (Cosmetic and Performance)Replies: 2Last Post: 09-27-2010, 05:03 PM -
Pulse adrenaline air filter
By Thomas in forum Modifications (Cosmetic and Performance)Replies: 1Last Post: 06-14-2010, 10:13 AM -
Pulse Adrenaline Clutch Cable
By sparky in forum Parts DeskReplies: 1Last Post: 06-06-2010, 03:44 PM