Results 11 to 16 of 16
|
-
#11 Re: Strange vibrations (QingQi 200gy)
-
#12 Re: Strange vibrations (QingQi 200gy)
-
#13 Re: Strange vibrations (QingQi 200gy)08-31-2011, 09:23 AM
Thanks for the advice. The "mechanics" in the bike shop took turns driving the bike around the block and all came back saying there's nothing wrong with and wouldn't check the things I asked them to check (as advised above) I got out the manual and removed the rear wheel myself took a look inside and couldn't see anythiing amiss, not that I would have notice anyway. Maybe the wheels were off balance. I gave up anyway, I'm used to it already so not as orried about it anymore.
. The qingqi doesn't have a cush drive btw. I guess I'll just have to wait and hope that when it does give in I wont be too far from civilisation.
-
#14 Re: Strange vibrations (QingQi 200gy)
- Join Date
- May 2008
- Posts
- 9
02-03-2012, 09:16 AMIt is the wheel bearings. Once they start making noise, total failure is not far away.
-
#15 Re: Strange vibrations (QingQi 200gy)02-04-2012, 05:48 PM
Hi there, I recently had this on my shineray xy125gy and I found out that there was a loose nut on the bolt holding the bottom on the rear shock, and a bolt going through the swingarm, I would just recomend going over everything and making sure everything is tight, hope this helps and hope you find out what the problem is :)
-
#16 Re: Strange vibrations (QingQi 200gy)02-05-2012, 08:36 PM
I had a similar problem with my Qingqi 200gy---- When I bought the bike, the "mechanics" I use that term very loosley, put the speedo drive on without any grease...the dry gearing in the drive started eating each other causing my bike to vibrate, and it came about suddenly as you described---might have a look there----It was amazing how many Kms I rode, before I had problems with it.... My speedo still worked, but the needle bounced a bit, and obviously, I had to replace the speedo drive....
« Previous Thread | Next Thread » |
Similar Threads
-
Stalling high rpm qingqi 200gy
By dacru in forum MaintenanceReplies: 7Last Post: 04-13-2010, 05:44 PM -
Qingqi 200GY-BA Motard Rear Suspension
By DeSaint in forum MaintenanceReplies: 14Last Post: 06-05-2009, 02:14 PM -
Head torque on QingQi 200GY?
By tinod in forum MaintenanceReplies: 2Last Post: 04-03-2009, 06:50 PM -
My Qingqi QM-200GY
By vladg in forum Welcome to MCM!Replies: 20Last Post: 10-16-2008, 08:54 PM