Thread: Zongshen zs250-5 not running
Results 1 to 7 of 7
|
-
#1 Zongshen zs250-5 not running
- Join Date
- Jun 2014
- Location
- Youngstown ohio
- Posts
- 5
06-22-2014, 07:39 AMHi I'm really new to the Chinese market scooter/bike bike scene. I recently purchased a non running 2006 zongshen zs250-5 and was wondering if there are any common problems that might keep it from running. I seem to read the carb has issues but I honestly the battery is dead and haven't charged it yet so I don't even know if it's getting power. From what some research I've done it seems that the 250cc motor is a common Yamaha "clone". Please correct me if I'm wrong. And any help is very appreciated. Also, is there like a Haynes manual that covered the 250cc bikes?
-
#2 Re: Zongshen zs250-5 not running
-
#3 Re: Zongshen zs250-5 not running
- Join Date
- Jun 2014
- Location
- Youngstown ohio
- Posts
- 5
06-24-2014, 03:54 PMSo today I charged the battery in my bike. I put the battery in and I have no power to anything. Any suggestions?
-
#4 Re: Zongshen zs250-5 not running06-24-2014, 04:49 PM
It's Multimeter's time.
Fuse OK?
-
#5 Re: Zongshen zs250-5 not running
- Join Date
- Jun 2014
- Location
- Youngstown ohio
- Posts
- 5
06-24-2014, 09:58 PMI went and worked on the bike alittle today. I was messing around with the starter solenoid and determined it was bad. The was no continuity between the terminals and the positive terminal was really loose. I didn't notice that the speedometer light was on but very dim. I tried the brake light and it shut all power off. I have a brand new spare battery I'm going to try tomorrow. Could it possibly be a bad ground also?
-
#6 Re: Zongshen zs250-5 not running
- Join Date
- Jun 2014
- Location
- Youngstown ohio
- Posts
- 5
06-24-2014, 10:00 PMAnd I also found a blown 15 amp fuse. That was on the solenoid and replaced that.
-
#7 Re: Zongshen zs250-5 not running
- Join Date
- Jun 2014
- Location
- Youngstown ohio
- Posts
- 5
06-28-2014, 03:50 PMSo today I got my yamaha starter solenoid. I put it in and smoke poured out of the bike. I melted a few wires and I wanted to know where I could buy a new complete wiring harness. I found a wiring harness for a zongshen zs250 GS and it seems to have similar connections. Would that work?
« Previous Thread | Next Thread » |
Similar Threads
-
Shineray xy300ste running problems
By CaptainSweatpants in forum ATV's/QuadsReplies: 4Last Post: 11-10-2012, 09:05 AM -
Zongshen ZS250 GS- HELP!
By WirralGhostHunter in forum Parts DeskReplies: 2Last Post: 07-20-2012, 06:20 PM -
Dangers of running lean
By spencer2004 in forum Modifications (Cosmetic and Performance)Replies: 8Last Post: 02-27-2012, 09:35 PM -
RMR 125 Running problem
By shaun69 in forum MaintenanceReplies: 12Last Post: 06-23-2011, 05:17 PM -
Cold Running
By choldy in forum MaintenanceReplies: 9Last Post: 12-27-2010, 02:03 PM