Sinnis Apache 250: FI dash light flashing red

[mark.evans101]

Pics from my bike, just for future reference, should anyone search this post:

Sinnis Apache 250 (EFI model, 2016) - QingQi QM250GY-F

IMG_20170527_100714.jpg

The dash has analogue rev counter on the left and a digital panel on the right.
The middle panel has lights to show current gear selected (top - showing green, N neutral in my pic) ,turn signals and a high beam light at the bottom
The digital panel has a speedometer, trip meter and milage reading, as well as a clock and petrol gauge. The odometer can be reset by the button on the far right that also switches modes between trip/total miles and clock/clock setup.

The offending FI red light is in the bottom left - its not on, just reflecting. It comes on at full intensity for a few seconds during the EFI start up check when the ignition key is first turned on then dims to that shown in the pic. My dealer confirmed its the Fuel Injection warning light that goes off after initial auto checking.

IMG_20170527_100847.jpg

Above, the EFI fuel injection system box, in the right hand side, as mentioned in the above posts.

Below pic can be ignored - can't seem to delete it after mistakenly uploading it, lol - my Pirelli Angel CTR