Quote Originally Posted by GUN ROD View Post
Finally got the seat I ordered and now installed. Stock seat was angled to the left. Found it was the welded front bracket was off. No bending was going to correct without possibly cracking frame. The new seat was designed for a Harley. Using the stock seat frame, I fabricated a 6"x13" 16 gauge plate with a rear break at 90 degrees (for strength) Attached stock bolts thru bottom, then two bolts up into the new seat. Allowed a straight installation. Allows a natural angle sitting or at rest. Rides great.seat 001.jpgseat 002.jpg



Did you paint some of your engine parts?