my point was that i am not removing the tank for a picture.

the bolts are bent on the tank from the assembly line. the tanks are shoved on to make them fit because the bolts and holes dont line up. when you look at it you will see one of the bolts bent over to the side more than the other, i bet that is the one that leaks. they will leak. once it starts thats it. call the place you bought it and get a new tank but dont shove it on to make it work. the holes need to be bigger for the tank to set into place.
i used a drill bit and ground out what i needed with the side of the bit after i let the tank show me where to grind by only setting it on top of the tabs. good luck all