Quote Originally Posted by barnone View Post
axa,
It was just a suggestion, no need to go off. Also what head are you talking about? They claim that the cylinder will fit. Positive feedback at
98.9%
not sure how you read text with such emotion, but i write with little.
suggestions are appreciated, though yours are usually more spot on...

anyway, for one, its a 69 mm piston thus you can guess why it wont fit, but in particular, what they measure as "Outer diameter of skirt:75mm" is far larger than the hole in your transmission.
Another is the lower rocker mount bolt is 90° out where it needs to be, there must be a ton of others, the head is for a different motor entirely.


anxious to know how your cooler works....
also to know if your paint job will stick to the head.
It seems all replacement/aftermarket parts are this gray textured paint that does not only look bad, but as you would imagine the texture grabs every bit of grease and grime.

i would think it would have been important to wash it down with soap and water (if not acetone) making it impeccably clean and perhaps first priming.
not that i know about these things...