Dong Fang DF 250 RTB Bobber Information

[barnone]

are there any docs on adjusting the valves? I read somewhere the first thing you do out of the create with these chinese bike was to check/adjust the valves, But I cant recall where I saw it at.

Aboshi,
Here is one by our own ChinaV, different bike but same procedure with a few differences.
http://www.mychinamoto.com/forums/sh...justing+valves
Pretty much the same as our bobber. I had to use an impact screw driver to remove the four screws that holds the plate covering the nut that you can use to turn the engine to get to the TDC mark. Another difference is you remove the three bolts to remove the valve cover instead of removing the two round valve covers.
Edit: Manual and sticker on frame both say .06mm intake and .08mm exhaust.