My new Chinese Enduro Bike "M-Bike JL200GY-2C"

[Kot]

But to outside look similar to Honda NXR 150 Bros Year 08/2011 of India and Brazil (PGM-Fi from 09)


The bike copy by Chinese looks very much like it....

[Kot]

Hi,

I have this very same model (I sent Kot a PM earlier to find out more about this bike). Good idea changing the bolts to stainless, thank you!

I think I will also lower it just a bit.

If I have anything else done, I'll let you know.

Thanks again...

Hi...Glad I can provide some help. Post your pic pls.
Kot

[Kot]

.
.
.
I got the rear pag foot rest from Kawasaki ZX9 for a long time
Mod is required.
It will look nice on the bike replacing the black metal one.

[Kot]

-Rode 78 Km and filled up 2.9 lte. Avg 26.9 km/ltr in traffic of BKK city, positive result.
-Remove 1 bolt at the cylinder head to frame to reduce deep shake at high RPM
-Mod the stock muffler, used 10mm drill all the way throuh and now got better flow
Before to get up to 90 KM/hr take awhile. Now I can hit 101 KM/hr easily.

FYI

[Kot]

- looking for the Handlebar raiser but could not find one yet. This I want to low the front fork down 2 inches






-Got new brake / clutch lever for CBR150r
Brake lever can fit without problem
Clutch can not, got to but bracket of CBR150 and replace the whole set

-Got new rear shock for Honda Fighter HX135

-Got the engine rev guage, will install at weekend

[Kot]

Clutch Lever and Bracket installed,
Front brake lever installed,

[Kot]

Got the handlebar riser

[Kot]

installed, work done last night.
Just got time to take pic in the morning at working place.

Front lower by 1 1/2 inch

[Kennon]

i would suggest a nice bar pad to set off the offroad looks abit more but it looks like your strengthening bar is too close to the handle abrs themselves to fit one

[Kot]

Easy Sunday, went to the weekend market and got some stuff


Cut the red alu into 2 pcs and installed as part of the rear foot rest from ZX9R
Look nicer after the job is done.







New look with new stickers and rear foot rest