QingQi (Qlink) 200GY Illustrated Valve Adjustment

[Basri]

Today checked the valve clearences, my bike is one of the Turkish version of QM200GY, 2006 Pioneer Takashi with 6300 kms on the clock.

I measured the inlet was 0.10 mm as well as the exhaust was 0.10 mm too, lucky me... I belive these are the factory settings..

Left them alone and closed the lids...Will check again after 5000 kms..

My personal opinion is; 0.10 mm clearence for both inlet and exhaust valves is the best value for these bikes, because, my bike starts at a second even in cold mornings, no valve noice at normal operation temperatures, very little valve noice only when engine is extremely hot.., Bike pulls like a train, incredible powerfull for a 200cc bike even on high gears at low speeds, don't have to lower the gear, just pull the gas and she speeds up..