Quote Originally Posted by barnone View Post
Aboshi,
Here is one by our own ChinaV, different bike but same procedure with a few differences.
http://www.mychinamoto.com/forums/sh...justing+valves
Pretty much the same as our bobber. I had to use an impact screw driver to remove the four screws that holds the plate covering the nut that you can use to turn the engine to get to the TDC mark. Another difference is you remove the three bolts to remove the valve cover instead of removing the two round valve covers.
Edit: Manual and sticker on frame both say .06mm intake and .08mm exhaust.
Sir, I believe you were looking for this...

I have been re-reading the thread and am getting familiar with where the posts are... LOL