CFMoto 650TR smartphone/GPS holder install

[bikerdoc]

650tr gps_ph holder 09.jpg

Device holder in horizontal position.

650tr gps_ph holder 10.jpg

RHS view of device holder with screen mounted.

650tr gps_ph holder 11.jpg

Horizontal position of device holder used given height of screen relative to device (Samsung Galaxy Note 2 or more commonly HTC HD2). If the two bottom "feet" are placed in-line with the holder then it is possible to still fit a larger device using a combination of the side clamps (spring-loaded ratchet system) and as an additional safety precaution I use a double banded hair-tie. This also helps with taking some of the shock from vibration - should there be any.

Slightly off topic... note the darkened areas over the idiot lights on each end of the instrument panel. I applied a layer of automotive window tint film over these sections to compensate for the overly bright festoon bulbs installed by CFMoto in the dash. The neutral and high beam indication lights were the most bothersome while riding at night. Both these lights give off far too much glare IMO, hindering clear field of vision in dark surroundings. Light pollution! The window tint does a great job of toning this down without detracting from the functionality of the lights, or the aesthetics of the instrument panel. I ended up adding two extra small rectangle 30x20mm areas of film over the two warning lights in question with good results as a single layer of film was not enough. Had to do the same with the Jetmax instrument panel too.