hey there everyone. Havent been around much, been dealing with life in general.
Can say that I am still riding, got in a replacement motor for the old one, and it did the trick. Not exact, but close enough. Seems the configuration is a bit smaller than the original. I had to fabricate some motor mount extensions for the front as they did don extend that far out off the motor. Anyway. She runs. Has a really hard vibration.Cruising around 40-45 is ok, but anything over that and the motor has this resonating sound about it, and the vibrations are horrendous.

May go after another motor, but they are not easy to locate.
Now on another note, I would like to replace my carburetor and wondered if this will do the trick.

http://www.ebay.com/itm/PZ30-30mm-Ga...pVjSWK&vxp=mtr

Or is there something else I should go for.
Plus one question. Where does that vacuum line from the bottom of the carb go to on the motor?

Well aside form that, if anyone has some input, great. I also hope that every ones holidays are rockin.