IMG_1372.jpgIMG_1373.jpgIMG_1374.JPGIMG_1376.jpgIMG_1377.jpg

I wrapped my pipe with exhaust wrap. Haven't burned my leg since. It's a lot more comfortable when stopped at a light. I added a chain tensioner, a little expensive, but easy to install and makes the ride a lot quieter, and smoother. Here is the site: http://www.monstercraftsman.com/powe...ain-tensioner/ I had to grind off the triangle on the frame holding the cross tube. Made sure there was clearance between the rear tire and it, and also that the chain was as close to center on the skateboard wheel as possible. Covered my seat with a fabric suede, and used a grey hemp cord to add the stitching along the rear. Near my front tire I strapped on a farming tube manual holder with stainless steel zip ties. Holds my tools and a copy of my paperwork. The custom paint job is a base of red engine paint, some stencils made with painters tape, and black engine paint. I removed the extraneous air parts, moved the ignition switch, and covered the air hole to the engine with a piece cut from a mint tint. Over 400 miles of smooth riding so far.