Quote Originally Posted by Bob form NV View Post
This is the filter I got. http://www.bikebandit.com/bikemaster...od-air-filters Spendy but not as much as but similar to the K&N. I had to modify it a bit by grinding a groove around the clamping flange so that things would clear the throttle mech. Model # is 3070940. Works good and looks nice I think. If you click my picture on the thread you can see what it looks like installed on my bike. The small breather I got at work, 3/8' pipe thread fits and works real nice also. I only have the one place but seems like every time I need a tool it's not where it's suppose to be.

Does the sprocket go on with out any mods except the chain length? I see some are making spacers, grinding things and buying bolts.
I made a spacer, i asked around and only found one other that did also.
If these JTR sprockets are all the same, i cant see how others are getting away with out it.
its about .055 thinner off the hub which makes it sit about half that toward the wheel...
thats nearly 1/32" off from stock, i don't see how that wont ware over time

Or maybe it just happens that original sprockets were out of alignment and the new ones fix it up... thats not what i observed though