Changing Crank position sensor from Kawasaki ER6 part number #59026-0018
This part is almost identical of CFmoto original.. however! there are few slight differences between parts.

1. Sensor part seems to sit slightly closer to timing rotor.
2. Sensor leads needs to be swapped as it seems CFMoto produce them with different pin order (same was the case of TPS sensor.)
3. Oil pressure rubber cap need to swap to CFMoto one as Kawasaki part is lot shorter.


Attachment 15263
Old part.
Attachment 15264
Case open
Attachment 15265
Rubber covers, left CFMoto and on the right Kawasaki part.




Also I did change clutch actuator and push rod from Kawasaki they were direct fit.
these where from 2009-2011 ER6.